LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1558 (Engine - 5.4L (3V) - F250 & F350) >> In-Vehicle Repair >> FLEXPLATE >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission. For additional information, refer to AUTOMATIC TRANSAXLE/TRANSMISSION - TORQSHIFT .
  2. Remove the 8 bolts and the flexplate.
    • To install, tighten to 80 Nm (59 lb-ft) in the sequence shown.
      Fig 1: Identifying Tightening Sequence For Flexplate Or Flywheel Bolts
      G03920141Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals