LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1558 (Engine - 5.4L (3V) - F250 & F350) >> In-Vehicle Repair >> Camshaft Roller Follower >> Installation

Camshaft Roller Follower: Installation

WARNING: This page is about a different car, the 2006 Ford Pickup and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    All camshaft roller followers 

    CAUTION: If the components are to be reinstalled, they must be installed into their original locations.
    NOTE: Lubricate the camshaft roller followers with clean engine oil prior to installation.
    Fig 1: Identifying Special Tool For Removing/Installing Camshaft Roller Followers
    G03919946Courtesy of FORD MOTOR CO.
  1. Using the special tool, compress the valve spring and install the camshaft roller follower.
  2. Repeat the previous step for each camshaft roller follower being serviced.

    3. LH camshaft roller followers 

  3. Install the LH valve cover. For additional information, refer to VALVE COVER - LH .

    4. RH camshaft roller followers 

  4. Using the special tools, align the engine support insulator studs and lower the engine.
    Fig 2: Identifying Special Engine Support Tools
    G04647876Courtesy of FORD MOTOR CO.
    5. CAUTION: Only use hand tools when installing the transmission mount-to-crossmember nuts or damage to the transmission mount can occur.
  5. Install the transmission mount-to-crossmember nuts.
    • Tighten to 103 Nm (76 lb-ft).
      Fig 3: Identifying Transmission Mount-To-Crossmember Nuts
      G03963913Courtesy of FORD MOTOR CO.
    6. CAUTION: Only use hand tools when installing the engine support insulator nuts or damage to the engine support insulators can occur.
    NOTE: RH shown, LH similar.
  6. Install the 6 RH and LH engine support insulator nuts.
    • Tighten to 103 Nm (76 lb-ft).
      Fig 4: Identifying Engine Mount Nuts
      G03919938Courtesy of FORD MOTOR CO.
  7. Install the 4 exhaust manifold-to-exhaust Y-pipe nuts.
    • Tighten to 40 Nm (30 lb-ft).
      Fig 5: Locating Exhaust Manifold-To-Pipe Nuts
      G03920889Courtesy of FORD MOTOR CO.
  8. Install the RH valve cover. For additional information, refer to VALVE COVER - RH .
  9. Install the generator. For additional information, refer to GENERATOR AND REGULATOR .
  10. Install the cooling fan shroud. For additional information, refer to ENGINE COOLING .
  11. Install the air cleaner and air cleaner air inlet tube. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
scientia non olet · About LEMON Manuals