LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1557 (Electronic Engine Control System - Gasoline - F250-F550 Super Duty) >> Removal And Installation >> Variable Camshaft Timing (VCT) Oil Control Solenoid - 5.4L >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the VCT oil control solenoid electrical connector.
    3. NOTE: Use compressed air to remove any foreign material from the VCT grommet prior to removing.
  3. Remove the VCT oil control solenoid grommet.
  4. Remove the bolt and the VCT oil control solenoid.
    • To install, tighten to 5 Nm (44 lb-in).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals