LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1557 (Electronic Engine Control System - Gasoline - F250-F550 Super Duty) >> Removal And Installation >> Powertrain Control Module (PCM) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to the INTRODUCTION - GASOLINE article for correct worldwide diagnostic system (WDS) hook-up procedure.
  1. If servicing the powertrain control module (PCM), connect the diagnostic tool to the vehicle. Allow the diagnostic tool to identify the vehicle and obtain configuration data.
    • All programmable module information will automatically be retrieved by the WDS.
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  3. Disconnect the PCM electrical connectors.
  4. Remove the 2 bolts and the PCM.
    • To install, tighten to 7 Nm (62 lb-in).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals