LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1557 (Electronic Engine Control System - Gasoline - F250-F550 Super Duty) >> Removal And Installation >> Knock Sensor (KS) - 6.8L >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the intake manifold. For additional information, refer to ENGINE - 6.8L (3V) .
  2. Disconnect the knock sensor (KS) electrical connector.
  3. Remove the 2 bolts and the 2 KS.
    • To install, tighten to 20 Nm (15 lb-ft).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals