Heated Oxygen Sensor (HO2S): Installation
WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Using the special tool, install the HO2S.
- To install, tighten to 46 Nm (34 lb-ft).
- Apply a light coat of high temperature nickel anti-seize lubricant to the HO2S threads prior to installation.
- Connect the HO2S electrical connector.
- Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .