LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1557 (Electronic Engine Control System - Gasoline - F250-F550 Super Duty) >> Removal And Installation >> Crankshaft Position (CKP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  3. Remove the accessory drive belt. For additional information, refer to ACCESSORY DRIVE .
  4. Disconnect the A/C compressor electrical connector.
  5. Remove the 3 bolts and position the A/C compressor aside.
    • To install, tighten to 25 Nm (18 lb-ft).
  6. Disconnect the CKP sensor electrical connector.
  7. Remove the bolt and the CKP sensor. Discard the O-ring seal.
    • To install, tighten to 10 Nm (89 lb-in).
    • Lubricate the new O-ring seal with clean engine oil prior to installation.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals