LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1555 (Engine Cooling System - F250-F550 Super Duty) >> Removal And Installation >> Block Heater - Gasoline Engines >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the engine cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
    2. CAUTION: Do not loosen the block heater retaining screw more than necessary for removal.
  2. Loosen the block heater retaining screw and remove the block heater.
    • To install, tighten to 2 Nm (18 lb-in).
    3. NOTE: Route the block heater power cable away from hot or rotating components, or damage to the cable can occur.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals