LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1551 (Wheels & Tires -- F250-F550 Super Duty) >> Removal And Installation >> Spare Tire Carrier >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Vehicle may be equipped with a spare tire lock. If so, the key is located in the glove compartment.
  1. Insert the drive end of the jack handle, with the spare tire carrier key attached, through the opening left of the license plate. Lower and remove the spare tire assembly.
  2. Remove the guide tube.
    Fig 1: Removing Guide Tube
    G04643214Courtesy of FORD MOTOR CO.
  3. Remove the 2 spare tire carrier bolts.
    • To install, tighten to 20 Nm (15 lb-ft).
  4. Remove the spare tire carrier.
    • Turn the spare tire carrier to release it from the tabs.
  5. Pull out the spare tire carrier lock.
    Fig 2: Pulling Out Spare Tire Carrier Lock
    G04643215Courtesy of FORD MOTOR CO.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals