Tie Rod End - Outer, F250-F350 Rear Wheel Drive (RWD)
WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOL CHART
| Remover, Steering Arm 211-003 (T64P-3590-F) |
NOTE:
Install a new tie-rod end if the ball stud is loose in the socket or the tie-rod end is bent. Install a new steering linkage stud dust seal if any nicks, cuts or tears are present. Do not attempt to straighten the steering linkage components.
- Place the steering wheel in the straight-ahead position.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Loosen the adjusting sleeve nut.
- Tighten to 55 Nm (41 lb-ft).
- Remove the cotter pin, retainer cap and outer tie-rod end nut.
- Discard the cotter pin.
- To install, tighten to 115 Nm (85 lb-ft).
- Discard the cotter pin.
- Using the special tool, disconnect the outer tie-rod end.
- Remove the outer tie-rod end.
- To install, reverse the removal procedure.
- Check and, if necessary, align the front end. For additional information, refer to SUSPENSION SYSTEM-GENERAL INFORMATION .
NOTE:
Count the number of turns required to remove the outer tie-rod end for reference during assembly.
CAUTION:
Make sure that the nut retainer cap is correctly positioned to allow for cotter pin installation. Do not tighten or loosen the nut to align the retainer cap with the cotter pin hole. Overtightening of the fasteners may result in premature failure of steering linkage components.
NOTE:
When repairing the steering linkage clean the steering linkage damper shaft of all corrosion and dirt. Buff the damper shaft smooth. Repairing the linkage changes the damper travel slightly. A dirty/corroded shaft can damage the damper seal and create a leak.