LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1546 (Transfer Case - Four Wheel Drive (4WD) Systems -- F250-F550 Super Duty) >> Removal And Installation >> Hublock >> Removal

Removal And Installation: Hublock: Removal

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    Dual rear wheel vehicles 

  1. Remove the rear wheels. For additional information, refer to WHEELS & TIRES .
  2. Remove the hub extender nuts and the hub extender.
    Fig 1: Locating Hub Extender Nuts
    G04650802Courtesy of FORD MOTOR CO.

    3. All vehicles 

  3. Loosen the hublock screws 1 to 2 turns.
  4. Use a small pry bar around the entire hub flange to release the gasket.
    Fig 2: Locating Entire Hub Flange
    G04650803Courtesy of FORD MOTOR CO.
  5. Remove and discard the hublock screws.
    Fig 3: Locating Hublock Screws
    G04650804Courtesy of FORD MOTOR CO.
    6. NOTE: Wiggle the axle shaft while sliding the hublock off of the splines to ease removal.
  6. Use a small pry bar around the entire hub flange and remove the hublock from the wheel hub.
  7. Remove the old gasket material completely and discard the O-ring.
  8. Clean the O-ring seal contact area as necessary to provide a good seal.
scientia non olet · About LEMON Manuals