LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1545 (Rear Suspension -- F250-F550 Super Duty) >> Removal And Installation >> Wheel Studs - Dual Rear Wheels >> Installation

Wheel Studs - Dual Rear Wheels: Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the new wheel stud aligning the serrations in the wheel extension made by the original wheel stud.
    Fig 1: Locating Wheel Stud Aligning Position
    G04643195Courtesy of FORD MOTOR CO.
  2. Place 4 washers over the outside end of the wheel stud and thread a standard wheel nut with the flat side against the washers. Tighten the wheel nut until the wheel stud seats against the back side of the wheel extension.
    Fig 2: Installing Wheel Stud
    G03883229Courtesy of FORD MOTOR CO.
  3. Remove the wheel nut and washers.
scientia non olet · About LEMON Manuals