Removal and Installation
WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Suspension fasteners are critical components because they affect performance of vital components and systems and their failure can result in major service expense. Install new components with the same component number or an equivalent component if installation is necessary. Do not use an installation component of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these components.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Remove and discard the stabilizer bar link lower nuts and washers.
- To install, tighten to 103 Nm (76 lb-ft).
- Remove and discard the stabilizer bar link upper nuts and washers and remove the stabilizer bar links.
- To install, tighten to 62 Nm (46 lb-ft).
- Remove the stabilizer bar bracket bolts, brackets and the stabilizer bar.
- Discard the bolts.
- To install, tighten to 40 Nm (30 lb-ft).
- Remove the stabilizer bar bracket nuts, U-bolts, brackets and the stabilizer bar.
- Discard the nuts and U-bolts.
- To install, tighten to 40 Nm (30 lb-ft).
- Remove the stabilizer bar bracket bolts, brackets and the stabilizer bar.
- Discard the bolts.
- To install, tighten to 80 Nm (59 lb-ft).
- To install, reverse the removal procedure.
All vehicles
F-350 vehicles equipped with Dana 80 axles
F-250 and all other F-350 vehicles
F-450 and F-550 vehicles
All vehicles