LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 154 (Parking Aid Systems) >> Removal & Installation >> Parking Aid Disable Switch

Parking Aid Disable Switch

WARNING: This page is about a different car, the 2002 Lincoln Blackwood. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch to LOCK position. Disconnect battery. Remove front floor console finish panel mat (if equipped). See Fig 1. Remove 2 front floor console finish panel screws.
  2. Lift front floor console finish panel to gain access to parking aid disable switch harness connector. Disconnect parking aid disable switch harness connector. Release parking aid disable switch-to-front floor console finish panel locking tabs. Remove parking aid disable switch. To install, reverse removal procedure.
Fig 1: Locating Front Floor Console Finish Panel Mat
G00012723Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals