LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1539 (Rear Drive Axle/Differential - DANA 80 -- F350 Super Duty) >> Disassembly And Assembly >> Differential Case and Ring Gear - Traction-Lok® >> Disassembly

Differential Case and Ring Gear - Traction-Lok®: Disassembly

WARNING: This page is about a different car, the 2006 Ford Pickup and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the differential case. For additional information, refer to DIFFERENTIAL CASE .
    NOTE: When refilling the axle with lubricant, first add 0.163 L (5.5 ounces) of friction modifier.
  2. Match-mark the differential case.
    1. Match-mark the differential case flange (ring gear) and button (cover) halves.
    2. Match-mark the differential pinion shafts and corresponding ramps.
      Fig 1: Identifying Match-Mark Differential Pinion Shafts
      G04643654Courtesy of FORD MOTOR CO.
    3. NOTE: An axle shaft held in a vise, with the shaft splines extending not more than 3 inches above the vise jaws, makes an excellent holding fixture for the differential case.
    Fig 2: Locating Differential Case Bolts
    G03883896Courtesy of FORD MOTOR CO.
  3. Loosen, but do not remove, the bolts.
  4. Place the differential assembly on a bench.
  5. Remove the bolts and the button half of the differential case.
    Fig 3: Locating Differential Case Bolts
    G03883896Courtesy of FORD MOTOR CO.
  6. Remove the differential side gear, side gear ring, rear axle disc and plate kit, differential pinion gears and the differential pinion shafts. Keep these parts in order for correct installation by placing them aside with the button half of the differential case.
    Fig 4: Locating Differential Side Gear, Side Gear Ring, Rear Axle Disc And Plate Kit
    G04643657Courtesy of FORD MOTOR CO.
  7. Remove the side gear ring and the rear axle disc and plate kit from the flange half of the differential case. Keep these parts in order by placing them on the pinion flange as shown.
    Fig 5: Locating Pinion Flange
    G04643658Courtesy of FORD MOTOR CO.
  8. Inspect the following components:
    • The clutch plates and clutch discs for cracks, excessive wear and distortion. Always install an entirely new rear axle disc and plate kit on both sides if discarding one or more of the clutch plates or clutch discs.
    • The differential pinion shafts and the ramp surfaces on the differential case for excessive wear or pitting.
    • The differential side gear and differential pinion gear teeth.
    • The differential side gear races that bear on the differential side gear rings.
scientia non olet · About LEMON Manuals