LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1538 (Rear Disc Brake System -- F250-F550 Super Duty) >> Removal And Installation >> Rear Disc Brake >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    Dual rear wheel brake disc 

    NOTE: The brake disc is part of the hub on all dual rear wheel axle applications.
  1. Remove the wheel bearing and hub assembly. For additional information on the Dana axle, refer to WHEEL HUBS AND BEARINGS - FULL FLOATING AXLE - DANA . For additional information on the Ford axle, refer to REAR DRIVE AXLE/DIFFERENTIAL - FORD 10.50-INCH RING GEAR
  2. Remove the disc-to-hub bolts.
    • To install, tighten to 121 Nm (89 lb-ft).

    3. Single rear wheel brake disc 

    CAUTION: Do not allow the brake caliper to hang from the brake hose or damage to the hose can occur.
  3. Remove the anchor plate bolts and position the brake caliper and anchor plate assembly aside.
    • Support the caliper and anchor plate using mechanic's wire.
    • To install, tighten to 275 Nm (203 lb-ft).
  4. Separate the brake disc from the hub.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals