LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1538 (Rear Disc Brake System -- F250-F550 Super Duty) >> Removal And Installation >> Rear Brake Caliper Support Bracket >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the parking brake shoes. For additional information, refer to PARKING BRAKE & ACTUATION .
  2. Release the parking brake cable from the LH parking brake assembly.
    Fig 1: Locating Parking Brake Cable At LH Bracket Assembly
    G03919405Courtesy of FORD MOTOR CO.
  3. Rotate the parking brake cable 90 degrees to release it from the parking brake actuating lever.
    Fig 2: Locating Parking Brake Actuating Levers
    G03919392Courtesy of FORD MOTOR CO.
  4. Remove the 4 brake caliper support bracket nuts.
    • To install, tighten to 137 Nm (101 lb-ft).
  5. Remove the brake caliper support bracket and the brake disc shield assembly.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals