LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1524 (Seat System) >> Disassembly And Assembly >> Seat Cushion - Rear >> Disassembly and Assembly

Disassembly and Assembly

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear seat cushion. For additional information, refer to SEAT CUSHION - REAR .
  2. Separate the J-strip and unzip the 2 zippers on each side of the cover and remove the rear seat cushion cover.
  3. Remove the rear seat base cushion.
  4. Remove the rear seat base.
  5. Remove the 2 bolts and the rear seat base bracket.
    • To install, tighten to 40 Nm (30 lb-ft).
  6. To assemble, reverse the disassembly procedure.
scientia non olet · About LEMON Manuals