Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the 2 wiper pivot arms nuts.
- To install, tighten to 35 Nm (26 lb-ft).
- Remove the LH and RH wiper pivot arms.
- Remove the 8 cowl panel grille pin-type retainers.
- Remove the 8 cowl panel grille caps and screws.
- Remove the LH cowl panel grille.
- Remove the RH cowl panel grille.
- To install, reverse the removal procedure.
- Adjust the wiper pivot arms. For additional information, refer to WIPERS AND WASHERS .