Selector Lever Knob: Removal

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Place the floor shift selector lever in the (D) position.

Fig 1: Locating Floor Shift Selector Lever In (D) Position
Courtesy of FORD MOTOR CO.
Gently pry up to remove the upper shift lever trim ring.

Fig 2: Identifying Upper Shift Lever Trim Ring
Courtesy of FORD MOTOR CO.
Remove the top finish panel.

Fig 3: Locating Top Finish Panel
Courtesy of FORD MOTOR CO.
Remove the set screw.

Fig 4: Locating Shift Knob Set Screw
Courtesy of FORD MOTOR CO.
Remove the knob and wiring by pulling straight up on the knob.

Fig 5: Removing Shift Knob And Wiring
Courtesy of FORD MOTOR CO.
Remove and discard the shifter straw by pulling it straight up.

Fig 6: Locating Shifter Straw
Courtesy of FORD MOTOR CO.