LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1515 (Evaporative Emissions - (Hybrid)) >> General Procedures >> Evaporative Emission System Leak Test >> Phase 1 - Leak Verification

Phase 1 - Leak Verification

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the VACUTEC smoke machine leak tester to the evaporative emission (EVAP) test port. For additional information, refer to .
  2. Close the canister vent solenoid. For additional information, refer to CANISTER VENT SOLENOID CLOSING PROCEDURE .
  3. Using the smoke machine, pressurize the EVAP system.
  4. Monitor the indicator flag on the smoke machine tester. If the measurement is below the indicator flag, the system has passed the leak test and the test procedure is complete. If the measurement is above the indicator flag, the system has failed the leak test. Proceed to PHASE 2 .
scientia non olet · About LEMON Manuals