Selector Lever Knob: Removal

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Place the floor shift selector lever in the (D) position.

Fig 1: Locating Floor Shift Selector Lever In (D) Position
Gently pry up to remove the upper shift lever trim ring.

Fig 2: Identifying Upper Shift Lever Trim Ring
Remove the top finish panel.

Fig 3: Locating Top Finish Panel
Remove the set screw.

Fig 4: Locating Shift Knob Set Screw
Remove the knob and wiring by pulling straight up on the knob.

Fig 5: Pulling Knob And Wiring Straight Up On Knob
Remove and discard the shifter straw by pulling it straight up.

Fig 6: Locating Shifter Straw