LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1512 (Electronic Engine Control System - 3.0L (4V)) >> Removal And Installation >> Camshaft Position (CMP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the camshaft position sensor (CMP) sensor electrical connector.
  3. Remove the bolt and the CMP.
    • To install, tighten to 10 Nm (89 lb-in).
    • Inspect the O-ring seal and install new as necessary.
    4. NOTE: Lubricate the CMP O-ring seal with clean engine oil.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals