LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1510 (Exterior Trim And Ornamentation) >> Removal And Installation >> Rocker Panel Moulding - Escape >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 2 rocker panel moulding screws.
    Fig 1: Removing Rocker Panel Moulding Screws
    G04622225Courtesy of FORD MOTOR CO.
  2. If equipped, remove the running board. For additional information, refer to RUNNING BOARD .
  3. Remove the 6 rocker panel moulding pin-type retainers.
    Fig 2: Removing Rocker Panel Moulding Pin-Type Retainers
    G04622226Courtesy of FORD MOTOR CO.
  4. Remove the rocker panel moulding.
    NOTE: When removing the rocker panel moulding use a wedge type tool to assist in the removal. Start at one end and proceed to the opposite end.
    NOTE: The rocker panel moulding retainer clips are one-time use only. New clips must be used during installation.
    Fig 3: Removing Rocker Panel Moulding
    G04622227Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals