Motor Electronics Pump

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Drain the motor electronics cooling system (MECS). For additional information, refer to MOTOR ELECTRONICS COOLING SYSTEM DRAINING AND FILLING .
Disconnect the inlet and outlet hoses.
- Disconnect the harness connector.
  
  Fig 1: Locating Motor Electronics Pump Inlet And Outlet Hoses
  Courtesy of FORD MOTOR CO.
Remove the bolts.
- To install, tighten to 20 Nm (15 lb-ft).
  
  Fig 2: Locating Motor Electronics Pump Bolts
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.