LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1507 (Engine - 2.3L - (Hybrid)) >> In-Vehicle Repair >> Valve Seals >> Installation

Valve Seals: Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the valve stem seal installation sleeve.
    Fig 1: Identifying Valve Stem Seal Installation Sleeve
    G04618995Courtesy of FORD MOTOR CO.
  2. Using the special tool, install the valve seal.
    Fig 2: Installing Valve Seal Using Special Tool (303-470)
    G04618996Courtesy of FORD MOTOR CO.
    3. NOTE: Check the seating of the valve collet.
  3. Using the special tools, install the valve spring.
    • Insert the valve spring and the valve spring retainer.
    • Compress the valve spring and install the valve collet using some grease and a small screwdriver.
      Fig 3: Identifying Special Tools (303-300, 303-350, 303-472)
      G03897813Courtesy of FORD MOTOR CO.
  4. Disconnect the compressed air supply.
  5. Install the spark plugs. For additional information, refer to INSTALLATION .
  6. Repeat the appropriate removal and installation steps for all of the other cylinders.
  7. Coat the valve tappets with clean engine oil and insert them.
  8. Install the camshafts. For additional information, refer to VALVE TRAIN COMPONENTS - EXPLODED VIEW  and CAMSHAFTS .
scientia non olet · About LEMON Manuals