LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1505 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Ignition Lock Cylinder >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Turn the ignition key to the ON position.
  3. Using a small tool, press the ignition lock cylinder release button and pull the ignition lock cylinder out.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals