LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1503 (Wiper System And Washer System) >> Removal And Installation >> Wiper Mounting Arm and Pivot Shaft >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cowl panel grille. For additional information, refer to FRONT END BODY PANELS .
  2. Remove the 3 windshield wiper mounting arm and pivot shaft assembly bolts and the windshield wiper mounting arm and pivot shaft assembly.
    • To install, tighten to 12 Nm (9 lb-ft).
  3. Disconnect the windshield wiper motor electrical connector.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals