LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1502 (Engine Emission Control - 3.0L (4V)) >> Removal And Installation >> Exhaust Manifold to Exhaust Gas Recirculation (EGR) Valve Tube >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Carefully detach the differential feedback exhaust gas recirculation (EGR) system sensor vacuum tubes and position the sensor aside.
  3. Disconnect the exhaust manifold-to-EGR tube fitting from the EGR valve.
    • To install, tighten to 40 Nm (30 lb-ft).
  4. Disconnect the exhaust manifold-to-exhaust EGR tube fitting from the RH exhaust manifold.
    • To install, tighten to 40 Nm (30 lb-ft).
  5. Remove the EGR valve tube.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals