LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1498 (Manual Transmission & Clutch System - General Information) >> General Procedures >> Flywheel Runout Check

Flywheel Runout Check

WARNING: This page is about a different car, the 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOL

G04620912
 Dial Indicator with Magnetic Base
100-D002 (D78P-4201-B) or equivalent
  1. Mount the special tool so that the indicator contact point rides on the straight edge which spans the clutch disc contact surface.
  2. Rotate the flywheel and check the runout. If the runout exceeds the maximum allowance, install a new flywheel.
    Fig 1: Checking Flywheel Runout
    G04620913Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals