LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1496 (Exterior Lighting System) >> Removal And Installation >> Side Lamp/Front Turn Signal Lamp Bulb >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the 2 fender splash shield bolts.
  3. Remove the 3 fender splash shield pin-type retainers.
  4. Remove the screw and position the fender splash shield aside.
  5. Remove the front turn lamp bulb holder from the lamp assembly.
    Fig 1: Front Turn Lamp Bulb Holder
    G04622046Courtesy of FORD MOTOR CO.
  6. Remove the front turn lamp bulb.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals