LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1496 (Exterior Lighting System) >> Removal And Installation >> Fog Lamp >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the 4 front fender splash shield bolts.
    • To install, tighten to 5 Nm (44 lb-in).
  3. Remove the 4 front fender splash shield pin-type retainers.
    • Position the front fender splash shield aside.
  4. Disconnect the fog lamp bulb electrical connector.
  5. Remove the 4 fog lamp screws and the fog lamp.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals