Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Prior to removal of the module, it is necessary to upload the module configuration information to the scan tool. For additional information, refer to MODULE CONFIGURATION .

Depower the supplemental restraint system (SRS). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
Lower the tilt steering column to the lowest position.
Remove the 2 screws and the instrument cluster finish panel.

Fig 1: Locating Instrument Cluster Finish Panel Screws
Courtesy of FORD MOTOR CO.
Remove the 4 instrument cluster screws and the instrument cluster.
- Disconnect the electrical connector.
To install, reverse the removal procedure.
- Download the instrument cluster configuration information from the scan tool into the new instrument cluster. For additional information, refer to MODULE CONFIGURATION .