Instrument Cluster Diagnostic Trouble Code (DTC) Index
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
INSTRUMENT CLUSTER DIAGNOSTIC TROUBLE CODE (DTC) INDEX
| DTC | Description | Source | Action |
|---|---|---|---|
| B1202 | Fuel Sender Circuit Open | Instrument Cluster | GO to PINPOINT TEST B . |
| B1204 | Fuel Sender Circuit Short to Ground | Instrument Cluster | GO to PINPOINT TEST B . |
| B1205 | EIC Switch Number 1 Assembly Circuit Failure | Instrument Cluster | CHECK the select/reset button for binding and sticking. If OK, INSTALL a new instrument cluster. REFER to INSTRUMENT CLUSTER . TEST the system for normal operation. |
| B1317 | Battery Voltage High | Instrument Cluster | REFER to CHARGING SYSTEM - GENERAL INFORMATION . |
| B1318 | Battery Voltage Low | Instrument Cluster | REFER to CHARGING SYSTEM - GENERAL INFORMATION . |
| B1342 | ECU is Defective | Instrument Cluster | CLEAR the DTCs. REPEAT the self-test. If DTC B1342 is retrieved again. INSTALL a new instrument cluster. REFER to INSTRUMENT CLUSTER . TEST the system for normal operation. |
| B2143 | NVM Memory Failure | Instrument Cluster | TURN the ignition switch to the ON position and OBSERVE the odometer display. Does the odometer display ERROR? If yes, INSTALL a new instrument cluster. REFER to INSTRUMENT CLUSTER . If the odometer does not display ERROR, CLEAR the DTCs. REPEAT the self-test. |
| B2477 | Module Configuration Failure | Instrument Cluster | REFER to MODULE CONFIGURATION . |
| U1900 | CAN Communication Bus Fault | Instrument Cluster | REFER to MODULE COMMUNICATIONS NETWORK . |
| All Other DTCs | - | Instrument Cluster | REFER to MULTIFUNCTION ELECTRONIC MODULES . |