LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 149 (Wiper/Washer Systems) >> Self-Diagnostic System >> Self-Diagnostics (Message Center)

Self-Diagnostics (Message Center)

WARNING: This page is about a different car, the 2002 Lincoln Blackwood. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Table shows results that are needed for diagnosis of WIPER/WASHER SYSTEM only. For complete diagnostic information on message center, see MODULE COMMUNICATIONS NETWORK - BLACKWOOD article.
NOTE: All vehicle doors must be closed and the engine must be running during message center self-test.

To enter message center self-test, press the E/M and MODE buttons at the same time while starting the vehicle. Release both buttons once the vehicle is running. To move through available tests, press MODE button until desired test is reached. See MESSAGE CENTER SELF TEST INDEX  table. To end message center self-test, turn ignition switch to OFF position. table, for message center self-test results.

MESSAGE CENTER SELF TEST INDEX

Numeric Display & Compass Display Test Description Result
__._ + rL Read Only Memory Test (1)
__._ + NL Non-Volatile Memory Test (1)
All Segments Displayed Display Test. Press E/M Button Until Display Cycles Through OFF, GRID 1, GRID 2, & GRID 3 (1)
__ + FF Fuel Flow Test (2)
__ + SP Speed Input Test (2)
(1) If display flashes at any time during test step, replace message center.
(2) If no signal is received, go to MODULE COMMUNICATIONS NETWORK - BLACKWOOD article.