LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1484 (Interior Trim And Ornamentation) >> Removal And Installation >> B-Pillar Trim Panel >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the safety belt D-ring cover and remove the safety belt bolt. To install, tighten to 53 Nm (39 lb-ft).
    NOTE: Inspect the safety belt D-ring cover for damage. If the safety belt D-ring cover does not remain in place, install a new cover.
  2. Position the front and rear door weatherstrips aside.
  3. Remove the cover, bolt and the upper B-pillar trim panel.
    • To install, tighten to 7 Nm (62 lb-in).
  4. Remove the 2 pin-type retainers and the front door scuff plate trim panel.
  5. Remove the pin-type retainer and the rear door scuff plate trim panel.
  6. Remove the lower B-pillar trim panel.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals