LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1481 (Manual Transmission) >> Disassembly And Assembly Of Subassemblies >> Differential - Front Wheel Drive (FWD) >> Assembly

Differential - Front Wheel Drive (FWD): Assembly

WARNING: This page is about a different car, the 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using a suitable press, install a new differential side bearing. Only use the inner bearing race to install.
    Fig 1: Installing Differential Side Bearing
    G04621052Courtesy of FORD MOTOR CO.
  2. Install the VSS drive gear.
  3. Install the spacer.
  4. Using a suitable press, install a new differential side bearing. Only use the inner bearing race to install.
    Fig 2: Installing Differential Side Bearing
    G04621053Courtesy of FORD MOTOR CO.
  5. Install the final drive gear and the 10 bolts.
    • Tighten in sequence to 120 Nm (89 lb-ft).
      Fig 3: Installing Final Drive Gear With Tightening Sequence
      G04621054Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals