LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1480 (Manual Transmission External Controls) >> Removal And Installation >> Gearshift Cables >> Removal

Gearshift Cables: Removal

WARNING: This page is about a different car, the 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the restraints control module (RCM). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
  2. Remove the floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
  3. Disconnect the gearshift cables from the transmission using the following procedure:
    NOTE: Both gearshift cables disconnect from the transmission in the same manner.
    1. Lift the gearshift cables out of the cable bracket.
    2. Disconnect the gearshift cables from the transaxle gearshift control assembly.
    3. Remove the 2 gearshift cable clips. SeeFig 1.
    4. Remove the 2 gearshift cable clips.
    5. Disconnect the 2 gearshift cables from the gearshift lever.
    6. Remove the 2 gearshift cable grommet nuts.
    7. Remove the gearshift cables.
    Fig 1: Disconnecting Gearshift Cables From Transaxle Gearshift Control Assembly
    G04621108Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals