LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1475 (Power Steering System) >> Removal And Installation >> Power Steering Pump Pulley - 3.0L (4V) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the 2 bolts and the RH splash shield.
    • To install, tighten to 7 Nm (62 lb-in).
  3. Loosen the power steering pump pulley bolt.
  4. Rotate the accessory drive belt tensioner counterclockwise and position the accessory drive belt aside.
  5. Remove the nut and the power steering pump pulley.
    • To install, tighten to 61 Nm (45 lb-ft).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals