LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1475 (Power Steering System) >> Removal And Installation >> Power Steering Fluid Reservoir >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: While repairing the power steering system, care should be taken to prevent the entry of contaminants or premature failure of the power steering components can result.
  1. Drain the power steering fluid into a suitable drain pan.
  2. Remove the 2 power steering pump reservoir bolts.
    • To install, tighten to 8 Nm (71 lb-in)
  3. Release the clamp and disconnect the power steering fluid cooler-to-fluid reservoir hose.
  4. Release the clamp and disconnect the power steering suction hose.
  5. Remove the power steering pump reservoir.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals