LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1473 (Rear Disc Brake System) >> Removal And Installation >> Rear Brake Pads >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the 2 brake caliper guide bolts.
    • To install, tighten to 35 Nm (26 lb-ft).
    3. CAUTION: Do not allow the brake caliper to hang by the brake caliper jounce hose.
  3. Remove the brake caliper and secure the brake caliper to the vehicle.
  4. Remove the inboard and outboard brake pads from the brake caliper.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals