LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1472 (HVAC Auxiliary Control System - (Hybrid)) >> Removal And Installation >> Battery Zone Valve >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the auxiliary climate control housing. For additional information, refer to AUXILIARY CLIMATE CONTROL HOUSING .
  2. Remove the 2 battery zone valve screws.
    • To install, tighten to 2 Nm (18 lb-in).
  3. Loosen the nuts and disconnect the battery zone valve fittings.
    • To install, tighten to 17 Nm (13 lb-ft).
  4. Disconnect the electrical connector and remove the battery zone valve.
  5. To install, reverse the removal procedure.
    • Install new O-ring seals.
scientia non olet · About LEMON Manuals