LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1464 (Engine Ignition - 3.0L (4V)) >> Removal And Installation >> Ignition Coil-On-Plug >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

    RH side 

    NOTE: The upper intake manifold must be removed to access the RH ignition coils only.
  1. Remove the upper intake manifold. For additional information, refer to ENGINE - 3.0L (4V) .

    2. Both sides 

  2. Disconnect the ignition coil electrical connectors.
  3. Remove the bolts and the ignition coils.
    • To install, tighten to 15 Nm (11 lb-ft).
      NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.
  4. To install, reverse the removal procedure.
    • Apply a small amount of dielectric grease to the inside of the ignition coil boots before attaching to the spark plugs.
scientia non olet · About LEMON Manuals