Torque Specifications
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Transmission selector lever bolt (4 required) | 25 | 18 | - |
| Shift cable bracket nut (2 required) | 23 | 17 | - |
| Transaxle control cable nut (2 required) | 22 | 16 | - |
| Transaxle control splash shield bolt (2 required) | 15 | 11 | - |
| Shift cable grommet nut (2 required) | 11 | 8 | - |
| Manual control lever retaining nut | 10 | - | 89 |
| Transaxle damper bolts (6 required) | 29 | 21 | - |
| Transaxle-to-engine bolt (10 required) | 47 | 35 | - |
| RH engine mount bracket nut (3 required) | 115 | 85 | - |
| RH engine mount bracket bolt | 115 | 85 | - |
| Front roll restrictor bolt | 115 | 85 | - |
| Lateral support crossmember bolt (4 required) | 115 | 85 | - |
| Front insulator through bolt | 115 | 85 | - |
| Rear roll restrictor-to-lateral support crossmember bolt | 90 | 66 | - |
| Engine support crossmember bolt (2 required) | 90 | 66 | - |
| Engine support crossmember nut | 175 | 129 | - |
| Front insulator bolt | 90 | 66 | - |
| Front insulator bolt (2 required) | 90 | 66 | - |
| Rear transaxle mount bolt | 90 | 66 | - |
| Rear transaxle mount nut (2 required) | 90 | 66 | - |
| Rear insulator mount bracket bolt (3 required) | 25 | 18 | - |
| Rear mount heat shield nut (2 required) | 38 | 28 | - |
| Rear mount nut (4 required) | 90 | 66 | - |
| Upper insulator support bolt (2 required) | 25 | 18 | - |
| Upper support bolt | 90 | 66 | - |
| Upper support nut (2 required) | 90 | 66 | - |
| Front wheel drive link shaft assembly bracket (4 required) | 47 | 35 | - |
| All-wheel drive link shaft assembly bracket bolt (6 required) | 47 | 35 | - |
| Link shaft bearing assembly-to-bracket nut (2 required) | 28 | 21 | - |
| Catalytic converter bracket bolt (2 required) | 25 | 18 | - |
| Catalytic converter bracket nut (2 required) | 25 | 18 | - |
| Rear insulator bolt | 90 | 66 | - |
| PTO housing assembly-to-transmission bolt (3 required) | 70 | 52 | - |
| PTO housing assembly-to-transmission bolt (1 required) | 47 | 35 | - |
| Motor electronics coolant pump bolt (2 required) | 20 | 15 | - |
| Motor electronics cooler bolt (2 required) | 6 | - | 53 |
| Motor electronics coolant temperature sensor | 20 | 15 | - |
| Auxiliary coolant pump bolts | 10 | - | 89 |
| Transaxle coolant tube fittings (inlet/outlet) | 50 | 37 | - |
| Transaxle ground cable nut | 20 | 15 | - |
| Transaxle harness retainer bolt | 25 | 18 | - |
| Fill plug | 40 | 30 | - |
| Drain plug | 40 | 30 | - |
| A/C compressor connector retainer | 25 | 18 | - |
| Engine control harness retainer nut (2 required) | 6 | - | 53 |