Differential Seals - LH: Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Using the special tool, install the LH differential seal.

Fig 1: Installing LH Differential Seal Using Special Tools
Courtesy of FORD MOTOR CO.
Install the LH halfshaft. For additional information, refer to INSTALLATION .
Using a small amount of thread sealant on the threads, install the transaxle drain plug.
- Tighten to 25 N.m (18 lb-ft).
  
  Fig 2: Identifying Transaxle Drain Plug
  Courtesy of FORD MOTOR CO.
Fill the transaxle with clean automatic transmission fluid.
Start the engine and run through all the gears and check fluid level.