On-Board Diagnostics With Diagnostic Tool
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- For detailed instructions and other diagnostic methods using the diagnostic tool, refer to INTRODUCTION - GASOLINE or diagnostic tool instruction guide.
- If using a generic diagnostic tool, refer to INTRODUCTION - GASOLINE for instructions on carrying out On-Board Diagnostics procedures.
The Quick Tests can be used to diagnose the powertrain control module, sensors and actuators of this transaxle.
The following is a guide for using the on-board diagnostic (OBD) Quick Tests and the diagnostic tool.
- Quick Test 1.0 - Visual Inspection
- Quick Test 2.0 - Set Up
- Quick Test 3.0 - Key On/Engine Off
- Quick Test 4.0 - Continuous Memory
- Quick Test 5.0 - Key On/Engine Running
- Special Test Mode
- Wiggle Test Mode
- Output Test Mode
- PCM Reset Mode
- Clearing DTCs
- OBD II Drive Cycle
- Other Diagnostic Tool Features
For additional information on other diagnostic testing features using the diagnostic tool, refer to INTRODUCTION - GASOLINE . Other diagnostic methods include the following:
- Parameter identification (PID) access mode, used to monitor sensors and actuators.
- Freeze frame data access mode, used to view emission-related data values from specific PIDs.
- Oxygen sensor monitor mode, used to monitor the oxygen sensor.