Diagnosis by Symptom Table Directions
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The powertrain control module (PCM) has an adaptive learn strategy to electronically control the transaxle. The adaptive learn strategy will automatically adjust the shift feel to the driver demands. The first few hundred miles of operation the transaxle may have abrupt shifts, this is a normal operation and will correct itself. If the battery has been disconnected for longer than 20 minutes the shift tables will reset and need to be relearned. Upshifting is controlled by the PCM. The PCM receives inputs from various engine and vehicle sensors along with driver demands to control shift scheduling, shift feel and torque converter clutch operation.
- Use the index and select the symptom/concern that best describes the condition.
- Turn to the routine indicated in the index.
- Always begin diagnosis of a symptom by using the following:
- Preliminary inspections
- Verification of condition
- Fluid level check
- Other test procedures as directed
- Begin with the electrical routine if indicated. Follow the reference or action required statements. Always carry out the On-Board Diagnostic Tests as required. Never skip steps. Repair as required. If the concern is still present after electrical diagnosis, proceed to the hydraulic/mechanical routine listed.
- The hydraulic/mechanical routines list possible hydraulic or mechanical components that could cause the concern. These components are listed in the removal sequence and by "most likely." All components listed must be inspected to verify correct servicing is carried out.
NOTE:
Not all concerns and conditions with electrical components will set a diagnostic trouble code (DTC). Be aware that components listed can still be the cause. Verify correct function of those components prior to proceeding to the hydraulic/mechanical routine listed.
DIAGNOSIS BY SYMPTOM INDEX
| Title | Routines | |||
|---|---|---|---|---|
| Electrical(1) | Hydraulic/Mechanical | |||
| Engagement Concerns | - | - | ||
| No Forward Only | 201 | 301 | ||
| No Reverse Only | 202 | 302 | ||
| Harsh Reverse or Forward | 203 | 303 | ||
| Delayed/Soft Reverse or Forward | 205 | 305 | ||
| No Forward and No Reverse | 207 | 307 | ||
| Shift Concerns | - | - | ||
| Some or All Shifts Missing | 210 | 310 | ||
| Shift Timing - Early/Late | 211 | 311 | ||
| Timing - Erratic/Hunting | 212 | 312 | ||
| Feel - Soft/Slipping | 213 | 313 | ||
| Feel - Harsh | 214 | 314 | ||
| No 1st Gear, Engages in Higher Gear ("D" Position) | 215 | 315 | ||
| No Manual 1st Gear (First in "D", OK) | 216 | 316 | ||
| Torque Converter Operation Concerns | - | - | ||
| No Apply | 240 | 340 | ||
| Always Applied/May Stall Engine | 214 | 341 | ||
| Cycling Shudder Chatter | 242 | 342 | ||
| Other Shift Concerns | - | - | ||
| Shift Lever Effort High | 251 | 351 | ||
| External Leaks | 252 | 352 | ||
| Vehicle Driveability Concerns | 253 | 353 | ||
| Noise/Vibration - Forward/Reverse | 254 | 354 | ||
| Engine will Not Crank | 255 | 355 | ||
| No PARK Range | 256 | 356 | ||
| Transaxle Overheating | 257 | 357 | ||
| No Engine Braking in Manual 1st Position | 258 | 358 | ||
| No Engine Braking in DRIVE (TCS ON) or Manual 2nd Position | 259 | 359 | ||
| Vehicle Movement with Gear Selector in the "N" Position | 262 | 362 | ||
|
||||