Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Drain the engine coolant. For additional information, refer to DRAINING .
- If removing the heater core hoses, remove the heater hose tie.
- Release the clamps and remove the necessary heater hose(s).
- To install, reverse the removal procedure.
NOTE:
Lubricate the coolant hoses with plain water only if needed.
- Fill the engine cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .