Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Drain the engine coolant. For additional information, refer to DRAINING .
- Remove the lower splash shield.
- Release the 2 clamps and disconnect the 2 auxiliary coolant flow pump heater hoses.
- Disconnect the auxiliary coolant flow pump electrical connector.
- Remove the 2 bolts and the auxiliary coolant flow pump.
- To install, tighten to 4 N.m (35 lb-in).
- To install, reverse the removal procedure.
- Fill the engine cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
NOTE:
Lubricate the coolant hoses with water if needed.