LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1456 (Electronic Engine Control System - 2.3L - (Hybrid)) >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation

Powertrain Control Module (PCM): Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the PCM and the stud bolts.
    • Tighten to 6 Nm (53 lb-in).
  2. Connect the 3 PCM electrical connectors.
  3. Attach the wiring harness retainer to the PCM stud bolt and install the nut
    • Tighten to 6 Nm (53 lb-in).
  4. Attach the ground strap to the PCM stud bolt and install the nut.
    • Tighten to 6 Nm (53 lb-in).
  5. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure. For additional information, refer to MODULE CONFIGURATION .
  6. Reprogram the passive anti-theft system (PATS). Carry out the Parameter Reset procedure. For additional information, refer to ANTI-THEFT - PATS - HYBRID .
  7. Reprogram the customers keys. Carry out the key programming using the diagnostic equipment procedure. For additional information, refer to ANTI-THEFT - PATS - HYBRID .
scientia non olet · About LEMON Manuals